Zebra 105SLPlus: Ribbon & Media Loading
Articles | Blog

Zebra 105SLPlus: Ribbon & Media Loading

105SL Plus Ribbon and Media loading. Open the media door. Pull out the Media Supply Guide. Place the roll of media on the supply hanger and push it back. Slide in the Media Supply Guide until it touches the edge of the role. Loosen the thumb screw under the outer media guide and slide the […]

Continue Reading...

Zebra ZD500 Series: Media Calibration
Articles | Blog

Zebra ZD500 Series: Media Calibration

Open the printer. verify the media sensor is in the correct location for label media. Place the supply media in the roll holders. Remove the first 3 inches or 80 mm of media from the liner. Place the leading edge of the first label under the Media Guides. Close the printer. Set the power seitch […]

Continue Reading...

Zebra ZD500 Series: Printer Features
Articles | Blog

Zebra ZD500 Series: Printer Features

The ZD500 printer is available in three media handling configurations: Standard, Label Dispenser, and Media Cutter models. The printer has a lighted display and control panel. Printer power and wired communication interfaces are located on the rear. Serial Port. Ethernet Port. USB Port. Parallel Port. DC Power Input Receptacle. Power Switch. External Media Feed Slot. […]

Continue Reading...

Zebra – ZT220: Manual Calibration
Articles | Blog

Zebra – ZT220: Manual Calibration

Calibrating the Ribbon in Media Sensors on the ZT220. If the printer fails to detect the size of the media correctly, you may have to manually calibrate the ribbon & media sensors. Press and hold pause and cancel for two seconds. The status light and supplies light flash yellow once, the pause light blinks yellow. […]

Continue Reading...